Environment
Novell ZENworks Configuration Management 10.3 Imaging
Novell ZENworks Configuration Management 11 Imaging
Novell ZENworks Configuration Management 11.1 Imaging
Novell ZENworks Configuration Management 11.2 Imaging
Novell ZENworks Configuration Management 11 Imaging
Novell ZENworks Configuration Management 11.1 Imaging
Novell ZENworks Configuration Management 11.2 Imaging
Situation
Intermittently, when PXE booting, the process fails with a message similar to
Trying to load: --
(the last few characters may vary). The message should say
Trying to load: z_auto.cfg
Trying to load: --
(the last few characters may vary). The message should say
Trying to load: z_auto.cfg
Resolution
This is fixed in version 11.2.1 - see KB 7010042 "ZENworks Configuration Management 11.2.1 - update information and list of fixes" which can be found at https://support.microfocus.com/kb/doc.php?id=7010042
Cause
A coding error causes a garbage filename to be returned by the zenimgweb library
Additional Information
If Trying to load: z_auto.cfg is seen in the PXE boot screen, then this TID does not apply