Environment
Novell ZENworks 11 Configuration Management ZENworks Control Center - ZCC
Novell ZENworks 10 Configuration Management with Support Pack 3 - 10.3 ZENworks Control Center - ZCC
Novell ZENworks 10 Configuration Management with Support Pack 2 - 10.2 ZENworks Control Center - ZCC
Novell ZENworks 10 Configuration Management with Support Pack 1 - 10.1 ZENworks Control Center - ZCC
Novell ZENworks 10 Configuration Management ZENworks Control Center - ZCC
Novell ZENworks 10 Configuration Management with Support Pack 2 - 10.2 ZENworks Control Center - ZCC
Novell ZENworks 10 Configuration Management with Support Pack 1 - 10.1 ZENworks Control Center - ZCC
Novell ZENworks 10 Configuration Management ZENworks Control Center - ZCC
Situation
Creating a filter for a Dynamic Workstation Group of "Machine - IP Address", "contains"
Entering partial IP address
When filter is saved, the partial address that was entered has been replaced with a complete IP address (the first matching address in the list)
Entering partial IP address
When filter is saved, the partial address that was entered has been replaced with a complete IP address (the first matching address in the list)
Resolution
For ZCM 10.3: This is fixed in version 10.3.2 - see KB 7007237 "ZENworks Configuration Management 10.3.2 - update information and list of fixes" which can be found at https://www.novell.com/support
For ZCM 11: This is fixed in version 11.1 - see KB 7008746 "ZENworks Configuration Management 11.1 - update information and list of fixes" which can be found at https://www.novell.com/support
Workaround: Press [tab] before saving the filter
Additional Information
The problem occurs if [Enter] is pressed when the cursor is in the field containing the partial address, which makes the browser select the first matching item.