Environment
Novell ZENworks 10 Configuration Management
Situation
1. Create an install bundle 1. Make sure to enable uninstall options
2. Assign this bundle 1 to the device
3. Create Bundle 2 that is a directive.
4. In Bundle2 Specify Action to Install Bundle 1.
5. Run Bundle2 on device
6. Create Bundle 3 that is a directive
7. Specify action to Uninstall Bundle 1.
8. Run Bundle 3 on the device.
2. Assign this bundle 1 to the device
3. Create Bundle 2 that is a directive.
4. In Bundle2 Specify Action to Install Bundle 1.
5. Run Bundle2 on device
6. Create Bundle 3 that is a directive
7. Specify action to Uninstall Bundle 1.
8. Run Bundle 3 on the device.
This will not work because Bundle 1 references Bundle 2.
Resolution
This is fixed in version 10.0.3 - see KB 3486285 "Updates to ZENworks 10 Configuration Management" which can be found at https://www.novell.com/support