A second Quicktask uses parameters from a previous Quicktask

  • 3320883
  • 29-Nov-2007
  • 30-Apr-2012

Environment

Novell ZENworks 10 Configuration Management

Situation

If you launch a Quicktask successfully, for example at the devices screen you do a Quicktask for all workstations of "launch application", then let that conclude. Then launch a Quicktask for all servers, such as reboot/shutdown - the "launch application" dialog is displayed

Resolution

This is fixed in version 10.0.1 - see KB 3486285 "Updates to ZENworks 10 Configuration Management" which can be found athttps://www.novell.com/support

Additional Information

This problem does not occur if you perform other actions in-between, only if the Quicktasks are performed one after the other.

Feedback service temporarily unavailable. For content questions or problems, please contact Support.