Integration [161] - OO Content for Micro Focus Network Automation

  • KM01694860
  • 11-Jun-2018
  • 11-Jun-2018


Integration Catalog


OO Content for Micro Focus Network Automation - Catalog Id: 161


This integration enables administrators to build Micro Focus OO flows that are integrated into Micro Focus Network Automation. To use this integration successfully, you should have administrator level knowledge of the Micro Focus Network Automation (NA) software, with a working knowledge of the NA command line interface (CLI) in particular.

The major use cases for the Micro Focus OO - Micro Focus Network Automation integration, along with the operations and flows that you can use to implement them, are as follows:
  1. Apply an update to multiple devices and roll back changes for all devices if any update fails:
    • List Iterator 
    • Run Command Script 
    • Rollback Device to Last Snapshot
  2. Check the status of a task:
    • List Tasks
  3. Change the configuration on a Cisco router, but roll back changes if the router becomes unreachable:
    • Get Configurations by IP  
    • Take Snapshot
    • Delayed Reload
    • Deploy Configuration
    • Cancel Delayed Reload
  4. Perform diagnostics on a list of network devices:
    • List Iterator 
    • Diagnose Device
    • List Diagnostic
    • Get Device Diagnostic
    • Generate Report From Lists
  5. Roll back device configuration to last snapshot:
    • Get Configurations By IP
    • Deploy Configuration

Note: Each use case has a corresponding flow in the Samples folder that implements it.


Leading Product:
Operations Orchestration Content

Secondary Product:
Network Automation



Documentation for this integration can be found using the following link:  


Support Matrix

Network Automation
Operations Orchestration Content
SupportedSupported (see comments)Not Supported

Generated: 6/11/2018 4:37:45 AM