Vivinet Diagnostics 2.x
What configuration is required for Nortel equipment?
What are the Software and Hardware pre-requisites for Nortel CS1000?
NetIQ Vivinet Diagnostics 2.x can monitor Nortel's CS 1000 systems. However, additional patches or components are required to ensure proper monitoring:
- Nortel CS1000 versions 3.0 and higher
- Phase II phones running firmware versions D98 (required) or D9C (recommended)
For version 5.0 devices:
? Nortel patch MPLR24316 must be installed on Call Servers. The patch corrects the entityPhysicalDescr MIB variable, which falsely reports IP telephony phones as Digital phones.
? Nortel software load MGCCAD35 or later must be installed on Media Gateway Controllers. The load enables OM Report retrieval.
For version 4.50 devices:
? Nortel patch MPLR21714 must be installed on Signaling Servers. The patch enables BMZ support and requires manual configuration on the Call Server; for more information, see the patch ReadMe.
? Nortel patch MPLR22309 must be installed on VGMCs. The patch enables VGMC trap retrieval.
? Nortel patch MPLR23300 must be installed on Call Servers. The patch corrects a problem with Call Server QoS messages containing the wrong severities.
? Nortel patch MPLR23560 must be installed on Call Servers. The patch corrects a problem with Zone statistics in which average bandwidth value may be higher than peak bandwidth value.
You can obtain all patches and software loads from your Nortel Support and maintenance provider.
If you need further assistance with the subject matter discussed in this Knowledge Base Article, please contact NetIQ Technical Support .