Resolution
goal
How can I remove exit program NW0001E from exit point QIBM_QTMT_WSG?
goal
I am upgrading to NetIQ Security Solutions for iSeries version 8.0 and am unclear about what to do about exit point QIBM_QTMT_WSG.
fact
NetIQ Security Solutions for iSeries
fact
NetIQ Security Solutions for iSeries 8.0
fix
How can I remove exit program NW0001E from exit point QIBM_QTMT_WSG?
goal
I am upgrading to NetIQ Security Solutions for iSeries version 8.0 and am unclear about what to do about exit point QIBM_QTMT_WSG.
fact
NetIQ Security Solutions for iSeries
fact
NetIQ Security Solutions for iSeries 8.0
fix
Beginning with IBM operating system version V5R2, IBM de-registered exit point QIBM_QTMT_WSG. If VigilEnt Security Agent for iSeries exit program NW0001E was attached to exit point QIBM_QTMT_WSG when the operating system upgrade was performed, the exit point did not get de-registered. You must manually remove the exit program and de-register the exit point.
To manually remove exit program NW0001E:
- On the command line, type
WRKREGINF
and press Enter. - Page down until you see exit point QIBM_QTMT_WSG.
- If exit point QIBM_QTMT_WSG is listed, type
8
(Work with Exit Points) in the Opt field to the left of the exit point and press Enter. - If exit point NW0001E is listed, remove it by performing the procedure outlined in knowledge base article NETIQKB46825.
Additional Information
Formerly known as NETIQKB48996