How can I push the Directory and Resource Administrator Agents to my Domain Controllers? (NETIQKB46682)

  • 7746682
  • 02-Feb-2007
  • 19-Jun-2007

Resolution

goal
How can I push the Directory and Resource Administrator Agents to my Domain Controllers?

goal
Do I have to register the Agents from each DRA server in the Multi-Master Set?

goal
Where is the setting to automatically install the NetIQ DRA Agent service on all domain controllers?

fact
Directory and Resource Administrator 7.x

fix

To install the Directory and Resource Administrator (DRA) Agents on the Domain Controllers in your managed domains:

  1. Start the Delegation and Configuration Console on the DRA server.
  2. Select the Configuration Management node in the left pane, then click Update Administration Server Options... in the right pane.
  3. On the General tab, check Automatically install the NetIQ DRA Agent service on all domain controllers.
  4. Click the Refresh Agents.
  5. Follow the instructions until you have completed configuration of the Automatically install the NetIQ DRA Agent service... setting. 
    • You have now pushed the Agents for this DRA server to all of the Domain Controllers in your managed domains.  
  6. Verify in the Application Event log on the DRA server the following events:
    • The response stating a success or failure of the Agent installation.
    • The DRA server registering itself with the agent.  Note:You should see a response from each Domain Controller in the domain.
    • >
    • Repeat this procedure to register the Agents from each DRA server in the Multi-Master Set, not just from the Primary DRA server.  Registering Agents is done on a per-DRA server basis.

For more information, contact Technical Support at www.netiq.com/support.

.


Additional Information

Formerly known as NETIQKB46682