Resolution
fact
VigilEnt Security Agent for iSeries 5.4/7.0
fact
VigilEnt Security Agent for AS/400 5.3/6.3
fact
VigilEnt Security Agent for AS/400 5.2/6.2
fact
VigilEnt Security Agent for AS/400 5.1/6.1
fact
VigilEnt Security Agent for iSeries PSAudit
fact
System Auditing and Reporting
fact
Changes to Object Authority Report
symptom
Data is not returned for the 'Changes to Object Authority' report in System Auditing and Reporting.
cause
The system value QAUDLVL did not specify *SECURITY.
fix
VigilEnt Security Agent for iSeries 5.4/7.0
fact
VigilEnt Security Agent for AS/400 5.3/6.3
fact
VigilEnt Security Agent for AS/400 5.2/6.2
fact
VigilEnt Security Agent for AS/400 5.1/6.1
fact
VigilEnt Security Agent for iSeries PSAudit
fact
System Auditing and Reporting
fact
Changes to Object Authority Report
symptom
Data is not returned for the 'Changes to Object Authority' report in System Auditing and Reporting.
cause
The system value QAUDLVL did not specify *SECURITY.
fix
Changes To Object Authority
This report includes all changes to object authorities and authorization lists.
Purpose
Use this report to review all authorization changes on your system. An adequate approach to satisfy auditor?s requirements is to run this report on a monthly basis.
Prerequisites
System value QAUDLVL must specify *SECURITY.
Below are the Command Types shown under column labeled 'Cmd Typ':
- RVK Revoke authority
- USR Grant User Authority (GRTUSRAUT)
- RPL Grant with replace
- GRT Grant authority
The 'Auth List' column shows the authorization list assigned to the object.
To Change the QUADLVL to *Security refer to the following steps:
- At a command line type PSMENU, press Enter.
- Select Option 1 PSAudit, press Enter.
- Select Option 1 System Auditing and Reporting, press Enter.
- Select Option 7 System Setup and Defaults, press Enter.
- Select Option 16 PSAudit Configuration Wizard, press Enter.
- Insert a '1' next to *Security in the QAUDLVL Auditing Options, press Enter.
Additional Information
Formerly known as NETIQKB31183