The Network Attribute 'Client Request Access' got set to *REGFAC when exit programs were installed a (NETIQKB31077)

fact
VigilEnt Security Agent for iSeries 5.4/7.0

fact
Remote Request Management (RRM)

symptom
The Network Attribute 'Client Request Access' got set to *REGFAC when exit programs were installed and now it shows *OBJAUT.

cause
This is a known issue where the Network Attribute 'Client Request Access' value is reset if Option 8 Work with Exit Points or Option 1 Work with Exit Programs is used.

fix

This issue has been resolved in the following PTF's:

• 1C01715, 1C01722 and 1C01727

Apply this listed PTF's (along with their pre-requisites and co-requisites), which can be obtained from the Support & Services site at www.netiq.com. 

A workaround (until the PTFs are applied) is to issue the following command after exiting either of the two menu options:

• CHGNETA PCSACC(*REGFAC)
  
  

note
The PTFs are now part of the 5.4/7.0 Service Packs beginning with 1X02267.  Service Packs can be requested by e-mail to vigilent-support@netiq.com.

Formerly known as NETIQKB31077