Resolution
goal
How do I communicate with an AS/400 that has multiple IP addresses?
fact
NetIQ Vulnerability Manager 5.0
fact
NetIQ Vulnerability Manager 5.5
fact
VigilEnt Security Agent for AS/400 5.2/6.2
fact
VigilEnt Security Agent for AS/400 5.3/6.3
fact
VigilEnt Security Agent for iSeries 5.4/7.0
fact
VigilEnt Security Manager 2.x
fact
VigilEnt Security Manager 3.x
fact
VigilEnt Security Manager 4.0
fact
VigilEnt Security Manager 4.1
fix
On the AS/400, run the command
How do I communicate with an AS/400 that has multiple IP addresses?
fact
NetIQ Vulnerability Manager 5.0
fact
NetIQ Vulnerability Manager 5.5
fact
VigilEnt Security Agent for AS/400 5.2/6.2
fact
VigilEnt Security Agent for AS/400 5.3/6.3
fact
VigilEnt Security Agent for iSeries 5.4/7.0
fact
VigilEnt Security Manager 2.x
fact
VigilEnt Security Manager 3.x
fact
VigilEnt Security Manager 4.0
fact
VigilEnt Security Manager 4.1
fix
On the AS/400, run the command
PSECONFIG
and change the AGENT INTERFACE
from *ANY
to the IP address of the AS/400 you used when you defined the AS/400 in Netiq Vulnerability Manager. Use F10 to update this, and then stop and start the ZPSE
subsystem.Additional Information
Formerly known as NETIQKB30790