What information does Exchange Migrator ignore when the 'EMCLI DIRSYNC /ClearTables' switch is used? (NETIQKB29319)

  • 7729319
  • 02-Feb-2007
  • 21-Nov-2007

Resolution

goal
What information does Exchange Migrator ignore when the 'EMCLI DIRSYNC /ClearTables' switch is used?

fact
Exchange Migrator 2.x

fix
When EMCLI DIRSYNC is run for the first time in a project, a new table is created called projectname_sync_to_target or projectname_sync_to_source. It holds mappings of accounts. If ClearTables is run, this table is dropped, deleting the current entries and recreating them based on the latest information. If an account with a matching SMTP address is found in the target, the mapping is recreated in the sync table. Furthermore, if no matching SMTP address is found, a new object is created, and that mapping is added to the new DIRSYNC table.

note
Additional information about EMCLI DIRSYNC is available in the following knowledge base article:

https://www.netiq.com/kb/esupport/consumer/esupport.asp?id=NETIQKB863

Additional Information

Formerly known as NETIQKB29319