Environment
Situation
Resolution
Installing Custom Installation Wizard
By default, the Custom Installation Wizard is not installed during the Extra! X-treme installation. CIW can be installed after the Extra! X-treme installation by copying the CIW files from the installation media.
Follow these steps to install the Custom Installation Wizard.
- After you install Extra! X-treme, open the Tools folder, located by default at:
Version 9.4: C:\~Micro Focus\Extra!-v9.x\Tools
Version 9.1 through 9.3: C:\~Attachmate\EXTRA!-v9.x\Tools
The Tools folder contains the following files:
CustomInstallationWizard.exe
CustomInstallationWizard.hlp
- Copy the two extracted files to your Extra! X-treme installation folder on your administrator workstation:
Version 9.4, new install on 64-bit - C:\Program Files (x86)\Micro Focus\Extra!
Version 9.4, new install on 32-bit: C:\Program Files\Micro Focus\Extra!
Version 9.1 through 9.3 on 64-bit: C:\Program Files (x86)\Attachmate\EXTRA!
Version 9.1 through 9.3 on 32-bit: C:\Program Files\Attachmate\EXTRA!
- Double-click CustomInstallationWizard.exe to start CIW.
Running the Custom Installation Wizard
For more information on running CIW, see Phase II, Customization in https://docs.attachmate.com/extra/x-treme/8.x/CentralManagementWalkthrough.pdf#page=29. Note: This PDF references Extra! X-treme 8.0; however, the information also applies to Extra! X-treme 9.x.
Additional Information
Legacy KB ID
This document was originally published as Attachmate Technical Note 2169.