Netware Remote Mode (signature scanning mode)

  • 7020877
  • 16-Mar-2009
  • 07-Aug-2017

Environment


GWAVA 4 112+
Netware

Situation

What is Netware Remote Mode?

Resolution


Netware Remote mode is needed if you are running your GroupWise system on Netware, and you still want to use the Signature engine.  In order to use the Signature engine,  GWAVA will need to be installed on a separate Linux system (physical or virtual).  After installing GWAVA on a Linux machine, you will need to go to the gwava management console on your Netware system and point it to the Linux system.

See the screenshot below.  10.1.28.11 is the IP address of the Linux machine.

Additional Information

This article was originally published in the GWAVA knowledgebase as article ID 1074.

Feedback service temporarily unavailable. For content questions or problems, please contact Support.