How To Set The Log Level For The Redline Control Center?

Document ID:7020678
Creation Date:15-Aug-2011
Modified Date:07-Aug-2017
- Micro Focus Products:
  GroupWise Monitoring and Reporting (Redline)

Environment

Redline 3.5

Situation

I am working on an issue with my Redline and trying to figure out how to set the Control Center logging to diagnostic?

Resolution

With Redline 3.5 the logging can now be configured in the Control Center web interface.

Load the Redline Control Center:

http://<ip/host>:6910

The Dashboard is the initial page that is loaded, click on Configure at the top of the page.

Select the Manage tab nested below the Configure tab.

At the bottom of the Control section, is the Debug Level which is the log level. The Debug Level can be set from 1 to 6, 6 being debug log level.

Set the level to 6.

Click OK to save.

Additional Information

This article was originally published in the GWAVA knowledgebase as article ID 2009.