After Running The set_net.sh Script, CTASD Still Does Not Load

After running the set_net.sh script ctasd.bin still fails to load

The /etc/hosts file may have an incorrect entry.  Follow these steps to make sure that the /etc/hosts file is setup correctly:

1) Login to the Linux machine via SSH


2) Browse to /etc


3) Run the command "cat hosts".  The result should look like the following:


4) If the result is different, modify the file to look similar to the image above:
127.0.0.1           locahost
xxx.xxx.xxx.xxx     HOSTNAME.domain     HOSTNAME

(xxx.xxx.xxx.xxx is the IP Address of the GWAVA server)

This article was originally published in the GWAVA knowledgebase as article ID 1498.