Status of profile does not show "Enabled"

  • 7019939
  • 20-Jan-2009
  • 29-Aug-2017




After enabling a profile in Reload the status does not show "Enabled" 


  • In some cases it is necessary to restart the Daemon to enable the reload profile/job.
  • Enable the desired profile
  • Exit out of all instances of reload
  • In a terminal window or a putty session type "reloadd restart" at a command prompt.
  • When the Daemon is done restarting the profile should show as "enabled"
  • Start reload

Additional Information

This article was originally published in the GWAVA knowledgebase as article ID 974.