Environment
Reload
Situation
After enabling a profile in Reload the status does not show "Enabled"
Resolution
In some cases it is necessary to restart the Daemon to enable the reload profile/job.
1.) Enable the desired profile
2.) Exit out of all instances of reload
3.) In a terminal window or a putty session type "reloadd restart" at a command prompt.
4.) When the Daemon is done restarting the profile should show as "enabled"
4.) Start reload
1.) Enable the desired profile
2.) Exit out of all instances of reload
3.) In a terminal window or a putty session type "reloadd restart" at a command prompt.
4.) When the Daemon is done restarting the profile should show as "enabled"
4.) Start reload
Additional Information
This article was originally published in the GWAVA knowledgebase as article ID 411