Configure Access mode POA to Auto-Load

  • 7019457
  • 19-Aug-2008
  • 29-Aug-2017


All versions of Reload


How to configure Reload to load the Access Mode POA automatically after a backup


1. Load "Reload Administration"
2. Profiles - Administer Profiles
(if you have a single po, the options will be different)
3. Groupwise Post Office Profile
4. Select profile
5. Preferences - Preferences Settings Menu
6. access backups Preferences
7. Press enter on "Load the Access Mode POA:" to Enable
8. Select <  Back  > at the bottom
9. Auto-Reload Preferences Menu
10. Press enter on Auto-Reload - Load the Most Recent Backup to Enable
11. After the next backup runs the Access mode poa will load automatically

Additional Information

This article was originally published in the GWAVA knowledgebase as article ID 386.