How is MCheck run against a GroupWise Mobility Server?

  • 7015825
  • 23-Oct-2014
  • 23-Oct-2014


Novell GroupWise Mobility Service 2.0


Looking at the documentation at the steps are very time consuming for systems with a large amount of mailboxes.  Instead the utility MCheck can be used.


Steps for using MCheck for this operation:
  1. Run MCheckSelect
  2. (Users) Select
  3. (Remove Event Configurations (Based on MAC Address))  Enter the MAC address from one of the Mobility Servers that just had it's IP address changed.

The tool will:

  1. Read all users on the Mobility server.
  2. Get all event configuration for a user.
  3. Check to see if the MAC address in any of the GroupWise event configurations matches the MAC address entered by the administrator.  If yes, it removes that event configuration.  The console will display all event configurations removed for each user.  It will display the total number of event configurations removed.