When adding primary servers into an existing zone there is no option to configure the ports used

  • 7015254
  • 20-Jun-2014
  • 20-Jun-2014

Environment

Novell ZENworks Configuration Management 11.2 Installation - Server
Novell ZENworks Configuration Management 11.3 Installation - Server

Situation

When installing an additional primary server into an existing zone, the installation does not have an option for selecting the ports used as it does on initial zone installation. The new server is installed with the ports that were configured in the original ZCM installation.


Status

Reported to Engineering

Feedback service temporarily unavailable. For content questions or problems, please contact Support.