Environment
Novell PlateSpin Protect 10
Novell PlateSpin Forge 3
Situation
When attempting to configure a newly added workload there is an "unexpected error" page. After opening the web UI logs using the link on this page the following error is seen:
Sequence contains more than one element
Resolution
Verify if any of the following software is installed on the source machine:
Novell PlateSpin Protect
Novell PlateSpin Migrate
PlateSpin Image Server
VMWare Server
If so the below steps will resolve the issue:
1. Remove the workload
2. Uninstall the software causing the error
3. Add the workload