Cannot view Linux Access Gateway clusters after upgrading to 3.1.2 IR3

  • 7007288
  • 02-Dec-2010
  • 26-Apr-2012


Novell Access Manager 3.1 Access Administration
Novell Access Manager 3.1 Linux Access Gateway


Administrator has Access Manager installed and working. After upgrading the solution to SP2 IR3, any new Linux Access Gateway (LAG) cluster that was created and assigned a LAG device would come up blank. There are no errors displayed.


Apply Access Manager 3.1.2 IR3a (3.1.2-347).

A workaround exists until patch is installed by doing the following:

- Using an ldap browser, connect to the Admin Console eDiretcory LDAP server (required secure LDAP to be enabled). - Browse to the following container:
There may be multiple group objects inside this container depending on whether there are other Identity Server, SSLVPN or LAG objects in the setup. Look at the romaAssociation attributes of each object and compare with the LAG ID that you just added to the cluster with the problem. The LAG IDs to IP address mappings are available from the Auditing -> General Logging section of the iManager interface if the ID is not clear.
- Once the LAG ID has been identified, delete the attribute  'romaApplianceGroupSAXMLDoc' from it's group objects.