How to determine the NMAS Radius client table is loaded correctly

The following steps describe how to determine if the client table for the Radius server is loaded correctly.
Load the radius server and before you type in the path to the DAS object you can switch screens to first load Radius debuglogging with the command
RADIUS DEBUGLOG ON
Then you can switch back to the Novell Radius Service screen to specify the DAS object and the password.
If you check the SYS:/ETC/RADIUS/DEBUG/RADDBG.LOG file you should see the following entry to confirm the client table is loaded correctly:
Cache: Successfully set up client table
In case the client table is not loaded successfully it can result in Unknown Radius Client messages at the time requests come in.