Environment
Novell Access Management 3 Linux Access Gateway
Novell Access Management 3 Access Administration
Situation
Installed the Linux Access Gateway (LAG) and wanted to configure
multiple static routes via the Access Administrator utility. Adding
one or two worked fine but as soon as the third or more static
routes were added, a warning would appear saying that the changed
were not applied. The actual message was
"Changes will not be applied until Apply Changes..."
The health screen would also give some additional information regarding the problem such as
Looking at the /var/log/ics_dyn.txt file on the Linux Access Gateway, an error would
"Changes will not be applied until Apply Changes..."
The health screen would also give some additional information regarding the problem such as
Static default route is configured.Looking at the routing table on the LAG with 'ip route sh', the routes added will not show up.
(Required Action) Re-apply the configuration with the 'apply' command.Gateway
147.2.16.254 status unknown, monitoring off.
(Required Action) Re-apply the configuration with the 'apply' command.Kernel
routing tables are missing entries.
(Required Action) Re-apply the configuration with the 'apply' command.
Looking at the /var/log/ics_dyn.txt file on the Linux Access Gateway, an error would
Resolution
Apply the Linux Access Gateway 70 build (available in Access
Manager IR1 patch). The problem only occured when secondary IP
addresses were added to the primary interface.