Environment
Novell NetWare 5.0 SP6a
Novell NetWare 5.1
Novell NetWare 6.0
Novell NetWare 6.5
Novell NetWare 5.1
Novell NetWare 6.0
Novell NetWare 6.5
Situation
How do I load CONLOG before the AUTOEXEC.NCF?
Resolution
Conlog must be loaded after the SYS: volume has mounted. This is completed at the end of LOADSTAGE 1, so LOADSTAGE 2 is the earliest that CONLOG can be loaded.
To load CONLOG at the end of LOADSTAGE 2, create a file called INSTAUTO.NCF in SYS:SYSTEM. Put the desired CONLOG command (i.e. LOAD CONLOG MAXIMUM=1024 ARCHIVE=YES) in this file and save it. To load CONLOG at the end of LOADSTAGE 3 place the command in NASAUTO.NCF. Start the server normally and Conlog will load at the end of the appropriate LOADSTAGE and before running AUTOEXEC.NCF
Additional Information
Formerly known as TID# 10063364