RPM list in bundle does not update properly when modifying RPM content

  • 3446316
  • 11-Apr-2007
  • 30-Apr-2012


Novell ZENworks Linux Management Linux Management 7 - ZLM7


Modifying a bundle with new RPMs, the RPM listing does not change to reflect the remove and uploads even after clicking APPLY and the version getting changed.

Both the old and new RPM show up in your uploaded RPM list when only the latest one should be there until you refresh.


To obtain early access to a hot patch with the fix for this problem, send an email to zen.feedback@novell.com with the subject of "ZLM7IR1 Hot Patch". An email reply will be sent with instructions on how to obtain the hot patch.

Additional Information

1. Create a new bundle. 2. Upload an RPM - (RPM has to be one that will have a newer version of to add later). 3. Mark it as Update when adding. 4. Go look at the bundle in ZENworks Control Center (ZCC) and make sure it looks good. 5. From that screen, click Upload RPM again. 6. Pick the new version of the RPM to upload.7. Both will be listed there. 8. Click the Apply Button - The version was updated from version 1 to version 2 but both rpms are still in the list. 9. Click Deploy and both are still listed. 10. Click the Details tab again to refresh the screen and one goes away.