Index for zisview does not match zisedit dnsserver

When viewing the DNS servers set via zisedit dnsserverx, zisview shows a different index to that used to set the dnsserver. zisview shows the indexes for the dnsservers as [0],[1], etc., but the zisedit command requires the use of 1,2, etc.

For example, at the bash prompt in the ZEN imaging environment, issue the command

zisedit DNSServerCount=2

(note that this works) then issue the command

zisedit DNSServer1=1.2.3.4

the message "Unknown parameter (0):'dnsserver1=1.2.3.4'" will be displayed.